Do not power off the device when the device starts.įor a modular switch with dual MPUs, remove the standby MPU before restarting the switch. Perform this operation during off-peak hours. This operation, however, will interrupt services and may cause the loss of configuration and data. You can power off and then power on the device to restart it. To access the BootROM/BootLoad menu, you need to restart the device. Now saving the current configuration to the slot 0. The current configuration will be written to the device. To prevent configuration loss after a device restart, save the device configuration.
WEB PASSWORD WIZARD 2 SERIAL PASSWORD
local-user admin123 password irreversible-cipher local-user admin123 service-type terminal
Change the console port login password.Idx Type Tx/Rx Modem Privi ActualPrivi Auth Int The command output shows that the privilege level of VTY1 is 15, which has the right to change the console port login password. Run the display user-interface command to check the permissions of all users. User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlagġ29 VTY 0 00:23:36 TEL 10.135.18.67 pass no Username : Unspecified Record the User-Intf field value ( VTY1). The line marked with a plus sign (+) indicates the current user. Run the display users command to check all the users who have logged in to the device. Use the STelnet account to log in to the device and ensure that the account has a privilege level of 3 or higher.
WEB PASSWORD WIZARD 2 SERIAL HOW TO
The following describes how to change the console port login password after logging in to the device using STelnet. If you have an STelnet or Telnet account and administrator permissions, you can log in to the device through STelnet or Telnet, change the console port login password, and save the configuration. Method 1: Log in to the device using STelnet or Telnet and change the console port login password.
0 kommentar(er)
